Fastening The Adapter Cover; Using The Security Bar And Slot - InFocus IN5132 User Manual

Fastening the adapter cover

When using the USB wireless adapter, be
sure to connect the adapter to the USB
TYPE A port furthest from the LAN port
and use the supplied adapter cover.
1.
Loosen the screw (marked with a
triangle) on the bottom left of the
USB TYPE A ports.
2.
Insert the cover tab into the hole at
the upper right of the USB TYPE A
ports in the direction of the arrow.
3.
Align the screw holes on the projector and the cover. Then
insert the screw removed from the projector into the hole
and tighten the screw.
WARNING
them in the mouth.
►Heat may build up in the USB wireless adapter. To avoid possible burns
disconnect the projector power cord for 10 minutes before touching the adapter.

Using the security bar and slot

A commercially available anti-theft cable
can be attached to the security bar on the
projector. Refer to the illustration to choose
an anti-theft cable.
This product also has a security slot for a
Kensington lock.
For details, see the security tool manual.
WARNING
from falling down, since this is not what it was designed for.
CAUTION
they may may become too hot.
NOTE
• The security bar and slot cannot prevent all thefts. They are intended
to deter thefts.
• The safety bar (4) can be used like the security bar.
►Keep small parts away from children and pets. Do not to put
►Do not use the security bars and slot to prevent the projector
►Do not place the anti-theft cable near the exhaust vents since
1
11mm
Anti-theft
cable
security bar
Setting up
2
Tab
3
Security slot
19mm
15mm
15