Brickcom CB-100A Series User Manual page 57

On the PTZ control section, click the arrow (marked by 3 on the
picture) for the Preset Point and Patrol section to come up.
To set up the pre-set point(s):
1. Determine the desired viewing direction and zoom level using
the PTZ commands.
2. Enter the name into the Current Position field (ex. Pre-set 1),
then click to create a new pre-set point. Click
delete an existing pre-set point.
3. On the drop-down list below the Current Position field, the
user can view all the configured pre-set points. When the user
selects a pre-set on the drop-down list and clicks
corresponding to the preset will be Immediately displayed.
To set up the patrol rule(s):
1. Enter the name into the Description field, then click
create a new patrol rule. Click
2. On the drop-down list below the Description field, the user
can view all the configured patrol rules. When the user selects a
patrol rule on the drop-down list and clicks
PC-NVR will run this rule endlessly. Click
- 50 -
, the image
to delete an existing rule.
, the BRC64
to stop the rule.
to
to