Health Check; Enable Health Check On The Fusion Dvr - Honeywell FUSION III DVR User Manual

Health Check

Enable Health Check on the Fusion DVR

________________________________________________________________________________________________________
Document 900.0803 Rev 8b
09/09
FVMS Health Check is used to monitor the status of Network, Video, Recording, and
HDD storage space on remotely connected Fusion DVRs. Health Check also provides
the user with detailed information on each of the DVRs connected, including the
software version running, whether cameras are recording in Motion or Continuous
mode and other important information. The DVR transmits this information on port
4005 (default). You can also enable E-mail alarms to be sent on a Health Check Event
(Warning or Failure event).
Highlights:
• Can monitor multiple DVRs on the Health Check Main page – up to 100 DVRs.
• Able to define the number of occurrences before a Warning or Failure alarm is
triggered.
• Check interval times allow FVMS to check the Fusion DVRs status once every 10
minutes or up to once every 7days.
• Independently enable or disable Health Check on each connected Fusion DVR.
• Independently select warning and failure notification counts for Video Loss,
Recording failures, Disk Free Space %, and Storage Failures.
• Enable custom Voice Warning on Failure alert.
• Detailed status screen provides the following information:
DVR Information: including last Health Check time, Total # of channels
o
recording, DVR software version running, current working drive, and
disconnected time.
Video and Recording information: including the recording status of each
o
camera channel and whether or not it is Motion or Continuous, and if there is
a Video Signal from each of the channels
HDD Storage Status Bar: indicates the amount of Free and Used space
o
remaining on the HDD.
•
Enable an E-mail to be sent on a Warning or Failure Health Check Event –
Enabled through the Admin>Enable Email Alarm setup window.
•
Ability to Export Status Summary Information, from each independently selected
DVR, to HTML, TXT, or Excel formats.
•
Summary information of Network Status, Disk Status, Video Status, Capture
Status and Storage Status indicating Good, Warning or Failure, along with the
specifics about each. Also includes the overall Total status of the DVR.
1. Enter Setup on the DVR.
2. Click the Network tab.
Clear the Disable Remote Control check box.
3.
4. Select the Enable Health Check check box.
Note The default connection port is 4005; only change this if necessary.
Click Apply.
5.
6. Click OK.
Fusion III DVR User Guide
145