Attaching the Two-Wire PTZ Adapter
Optional Components
________________________________________________________________________________________________________
Document 900.0803 Rev 8b
09/09
Signal Line (-)
1.
Locate the PTZ adapter cable (included in the Fusion accessory box).
Connect the two wires of the PTZ adapter to the PTZ camera. The red wire on the
2.
adapter should connect to the RX+ on the PTZ and the white wire should connect
to the RX-.
3.
Connect the other end of the adapter to the DVR as shown.
Assign the PTZ camera an ID number that coincides with the number assigned to
4.
it by the DVR in the PTZ Setup Interface.
Example: If the camera is plugged into input 5, set the PTZ unit to ID number 5.
To fully utilize the potential of the DVR, several optional Fusion components are listed
below. Contact a dealer for more information.
•
USB External Hard Drive
•
Fiber Network Interface Adapter
•
Gigabit 10/100/1000 NIC Adapter
•
Fusion Remote Video Software
•
External 3U Chassis SATA Storage
up to 32 TB
•
4CH Multiplexed Analog Output card
•
Honeywell Video Analytics Software
•
Fusion Video Management Software
Fusion III DVR User Guide
Signal Line (+)
Ground
PTZ Adapter
•
USB Modem
•
4 Port Analog Output Card
•
16 Port Audio Card
•
External 1U Chassis SATA Storage
up to 8 Terabyte
•
HVR/NVR Upgrade
•
Internal Raid 5
•
IDM (Integrated Data Manager)
•
SCSI Adaptor
35