Turning On The Dvr; Turning Off The Dvr - Honeywell FUSION III DVR User Manual

Getting Started

Turning On the DVR

Turning Off the DVR

________________________________________________________________________________________________________
36
Once the cables have been properly connected, it is time to turn on the power.
Turn on the monitor and any external peripherals (ex. Printers, External Storage
1.
Devices, etc.) connected to the DVR.
2. Turn on the main power switch located on the front of the DVR as shown below.
The DVR will run a series of self-tests. After two or three minutes, a series of messages
may be displayed as the various hardware and software subsystems are activated.
Under normal circumstances the user should not be asked to respond to these
messages. If asked to respond to the messages (adding a Printer, Monitor, etc., for the
first time) follow the instructions carefully.
1. Select the Exit button from the main screen.
Select Yes. The DVR will shut itself off automatically once this is done.
2.
The DVR may take several minutes to shut down completely
Caution Always be sure to follow the proper procedures when turning off the power
to the DVR. NEVER disconnect the power to the DVR while it is still running
or in the process of shutting down. Doing so can cause data loss, file
corruption, system instability and hardware failure.