Windows For Workgroups/Ndis 2 Installation - 3Com 3C389 User Manual

3-6 C
HAPTER

Windows for Workgroups/NDIS 2 Installation

If you are installing the 3C389 PC Card in a PC that
already has Windows for Workgroups installed, refer to
the Microsoft Windows for Workgroups User's Guide for
instructions on how to install and configure a third-party
device driver.
If you are running Windows for Workgroups Version 3.11,
perform the following procedure:
1 At the Network Setup window, select Networks,
then Install Microsoft Windows Network.
2 Change any other items for your environment, and
click OK and Continue.
3 When prompted to install a new PC Card, select
Unlisted or Updated Network Adapter.
4 When prompted to insert a diskette that contains
the network driver, insert TokenDisk diskette #2 and
click OK.
5 Follow the instructions as they appear on the
window to install the device driver.
6 Accept the defaults for Interrupt, MMIO, and SRAM.
You will be given a chance to update these later, if
necessary.
7 Exit the Windows for Workgroups setup.
8 Exit to the DOS prompt. Do not reboot your PC at
this time.
9 Configure the 3C389 PC Card using LANAID.
See Chapter 5 for information on how to use LANAID.
10 If LANAID is not already installed, install it as
described in Chapter 4 in the section "Installing
LANAID."
11 After LANAID is installed, continue with Chapter 4
"Using LANAID to Configure the 3C389 PC Card."
When you get to the panel that asks for the existing
network operating system, select Microsoft windows for
workgroups.
3: I N
NSTALLING THE
D
ETWORK RIVERS