Retry Count; Send Timeout; Ungroup - 3Com EtherLink 3C980C-TXM User Manual

62 C 4: I
HAPTER

retry count

This command sets the number of retries that the software
attempts when a probe packet fails to appear at the receive
end. After the retries, the software puts the board in Wait
mode. If no argument is specified or the specified
argument is invalid, the current value is displayed.
Otherwise, the new value is displayed.
Syntax
Example
Default

send timeout

This command sets the timeout value, in seconds, that the
software waits before retransmitting a probe packet when
a send request to the link support layer (LSL) is not
acknowledged. A message is displayed for each loaded
frame type.
Syntax
Example
Default

ungroup

This command deletes a group. The LAN driver for the
group must not be loaded. The following message appears
for all frame types that the NIC supports:
Cleaning up resources for group associated
with Primary Slot #xxxx.
Syntax
Example
Default
C
NSTALLING AND ONFIGURING IN
lbrsl retry count number_of_retries
where:
number_of_retries is any positive integer
lbrsl retry count 2
5
lbrsl send timeout pri_slot seconds
where:
pri_slot is the PCI slot number of the primary NIC.
seconds is the time in seconds.
lbrsl send timeout 1001 10
10
lbrsl ungroup pri_slot
where:
pri_slot is the PCI slot number of the primary NIC.
lbrsl ungroup 10001
None
N W
ET ARE