Install Server Features; Configure Groups - 3Com EtherLink 3C980C-TXM User Manual

c Save parameters and load the driver
2 Repeat the process for all NICs to be set up.
3 After all NICs are set up, press Esc several times to
return to the Installation Options screen.

Install Server Features

Two drivers are associated with DynamicAccess technology
server features under NetWare: SE and LBRSL.
1 From the Configuration Options screen select
Product options.
2 Select Install a product not listed.
The following message appears:
Product will be installed from A:\. If you are
installing from floppy, insert the first
diskette of the product you want to install
into the drive and verify that the path above
is correct.
3 Press F3.
4 Enter this command:
3C980C_TXM:\nwserver
The following message appears:
Product "3Com DynamicAccess Server Features"
was found. Verify that this is the product you
want to install before proceeding.
5 Press Enter.
The system copies the DynamicAccess technology server
features software to the SYS volume.
Configure Groups
1 Press Esc to return to the Installation Options screen.
2 From the Configuration Options screen, select
NCF files options (create/edit server startup files)
Installation and Configuration Instructions
Press <F3> to specify a different path;
Press <ENTER> to continue.
Press <ENTER> to continue.
Press <ESC> to abort installation.
49