Specifying Traffic Priorities; Saving The Configuration - 3Com EtherLink 3C980C-TXM User Manual

c Click Configure.
d In the NIC Properties window, click TCP/IP.
e In the next window, configure the IP address and subnet
Specifying Traffic Priorities
You can use the DynamicAccess Software Setup window to
specify traffic priorities.
1 Double-click the 3Com DynamicAccess icon in the
Windows Control Panel.
The DynamicAccess Software Setup window appears.
2 Click the appropriate tab:
For detailed information on DynamicAccess software,
go to:
http://www.3com.com/dynamicaccess
Saving the Configuration
To save and exit, click OK.
A prompt asks whether you want to configure traffic
prioritization. If you click Yes, the DynamicAccess Software
Setup window appears.
To exit without saving the configuration, click Cancel.
mask.
Traffic Prioritization—Prioritize applications to ease
bottlenecks in the network and allow critical
applications to take network precedence. You can turn
traffic prioritization on or off independently for:
Each NIC that is not in a group and does not have
VLANs
Each group that does not have VLANs
Each VLAN
Each virtual NIC (NIC, group, or VLAN) shown in the
Traffic Prioritization control panel
Administration—Set DynamicAccess control panel
access, set VLAN options, enable efficient multicast
control, and enable the prioritizing of multicast traffic.
Configuring Groups and VLANs 39