Wait Timeout; Troubleshooting A Group Configuration - 3Com EtherLink 3C980C-TXM User Manual

wait timeout

This command sets the timeout value, in seconds, that the
software waits before marking a NIC that is in wait mode
as failed (see
the specified argument is invalid, the current value is
displayed. Otherwise, the new value is displayed.
Syntax
Example
Default
Troubleshooting a Group Configuration
Use the troubleshooting tips below to solve problems that
may occur in a group configuration.
To access a database of technical information that can
help you diagnose and solve NIC installation,
configuration, and upgrade problems, go to:
http://knowledgebase.3com.com
Table 4 Troubleshooting Groups In NetWare
Symptom
More than one non-3Com server NIC
has been detected in one or more
groups on this server.
retry count). If no argument is specified or if
lbrsl wait timeout seconds
where:
seconds is any positive integer.
lbrsl wait timeout 2
1
Tip
You can use only one NIC that is not a
3Com server NIC in one 3Com load
balancing/RSL group per server. Check
the groups and remove all but one of
the non-3Com server NICs from the
groups.
Maintaining Groups 63