Table 11: Channels Page Definitions - Grandstream Networks GXW410x User Manual

Apply test results
automatically
Apply test results to all
ports
Error Timeout
T 11: C
ABLE HANNELS
Channels
SIP User ID
Authentication ID
Authentication Password
Profile ID
Call Progress Tones
Channel Voice Settings
Tx to PSTN Audio Gain (dB)
Rx from PSTN Audio Gain
(dB)
Silence Suppression
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Default is No. If selected on Yes, then all the results from the test will be applied
automatically. If you select No you will have to monitor the Syslog output. This is only
reserved for very advanced users.
Default is No. If selected on Yes, then all the test results will be applied to all ports on
the gateway. If all the lines belong to the same service provider or PBX it will make
sense to apply the results to all ports.
This is the time the gateway will wait to exit the test mode, when something
unexpected or an error has occurred.
P D
AGE EFINITIONS
Note – The channels here are basically SIP endpoints that will act as clients
registering to the SIP Server configured under the appropriate Profile page.
It should be set same as the channel number (i.e 1, 2..4 or 8 depending on number of
FXO ports). It is NOT the same as SIP Account ID.
This is the SIP account information. Enter the SIP User ID part of the account.
SIP service subscriber's Authenticate ID used for authentication. It can be identical
to, or different from SIP User ID.
SIP account password needs to be entered here.
Note: After entering the password, it will show up as blank but the password still
remains active.
Select the corresponding Profile ID (1/2/3). Profiles are SIP Server configurations.
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies.
Frequencies should be configured with known values to avoid uncomfortable high
pitch sounds. ON is the period of ringing (ON time in ms) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring
ON ms and a pause of OFF ms and then repeat the pattern.
"Dial tone"
"Ringback tone"
"Busy/Re­order tone"
"Confirmation tone"
Please refer the document below to determine your local call progress tones
(http://www.itu.int/ITU­T/inr/forms/files/tones­0203.pdf) or run the FXO Line Test
(Table 10).
Channel voice settings mentioned below.
Allows user to set a value in dB for transmission to PSTN Audio Gain. Default is 1.
Range is from ­12 to 12dB.
Allows user to set a value in dB for receive from PSTN Audio Gain. Default is 0.
Range is from ­12 to 12dB.
This controls the silence suppression/VAD feature of G723 and G729. If set to "Yes",
when a silence is detected, small quantity of VAD packets (instead of audio packets)
will be sent during the period of no talking. If set to "No", this feature is disabled.