Epson EMP-835 User Manual page 81

List of Configuration Menu Commands
Signal
The items that can be set will vary depending on the input source that is currently being projected. Setting details are saved separately for each source.
If using the EMP-835, you cannot change any of the "Signal" configuration menu settings while EasyMP is running.
*1
Auto Setup
*1
Resolution
*1
Tracking Depends on image signal
*1
Sync. Depends on image signal
Position
*1
Preset
*2
Progressive
*3
Computer1 Input
Auto , RGB, Component Video
*3
Computer2 Input
Auto , RGB, Component Video
This sets the automatic adjustment function to "ON" or "OFF", to control whether images are
ON , OFF
automatically adjusted to the optimum condition when the image signal is changed.
"Auto" function sets the resolution for image signal automatically. When this function doesn't work
Auto , Manual
resulting in improper projection, you may need to input the resolution manually.
Adjusts images when vertical striped patterns appear.
Adjusts images when flickering, fuzziness or horizontal interference occur.
Adjusts the vertical and horizontal display position for images.
Records the setting values for the "Image" and "Signal" configuration menus.
1, 2, 3, 4, 5
Converts each field of interlaced (I) signals to progressive (P) signals. This is ideal for use when
OFF
viewing images with a large amount of movement in them.
Video Carries out IP conversion. Sets the
images.
Film/Auto This setting should normally be used. The image source is determined automatically, and if the
images are judged to be film images, they are reproduced with almost the same image quality as the
original.
Selects the image signals from equipment that is connected to the [Computer1/Component] or
[Computer2/Component] port. With the "Auto" function, image signals are recognized automatically.
If the colours do not appear correctly when you select "Auto", select the appropriate signal for the
connected equipment manually.
sp.75
g
film judgment function to "OFF". Suitable for normal video
User's Guide
80
Default setting values
sp.76