Epson EMP-835 User Manual page 51

Preventing Theft (Password Protect) Preventing Theft (Password Protect)
Enable "User's Logo Protect".
4
(1) Select "User's Logo Protect" and then press the [Enter]
button on either the remote control or the projector's
control panel.
(2) Select "ON" and then press the [Enter] button on either the
remote control or the projector's control panel.
(3) Press the [Esc] button on either the remote control or the
projector's control panel.
Enter the password.
5
(1) Select "Password" and press the [Enter] button on either
the remote control or the projector's control panel.
(2) When the message "Change the password?" is displayed,
select "Yes" and then press the [Enter] button on either the
remote control or the projector's control panel.
The default setting for the password is "0000", and you can
change it to the required password.
If you select "No", the display will return to the screen in
step 1.
(3) Enables numeric keypad of the remote control and enter a
4-digit password.
The password entered will be displayed as "****".
Once four digits have been entered, the confirmation
screen will be displayed.
(4) Re-enter the password to confirm.
The message "The new password is stored." will be
displayed.
If you enter the password incorrectly, a message will be
displayed prompting you to re-enter the password.
Once the settings are complete, press the [Menu]
6
button.
TIP
• When the set time has elapsed and the password is entered,
projection will start and the "Time-elapsed" counter will be cleared
to count again.
• Make a note of the password so that you do not forget it and keep it
in a safe place.
• If you lose the remote control, you will not be able to enter the
password. Keep the remote control in a safe place at all times.
User's Guide
50