Preventing Theft (Password Protect); When Password Protect Is Enabled; When "Power On Protect" Is Enabled (On) - Epson EMP-835 User Manual

Preventing Theft (Password Protect)

When the Password Protect function is enabled, people who do not know the
password cannot project images even though they can turn on the projector's
power. Furthermore, it will not be possible to change the company logo or
other logo that is displayed when the power is turned on. This can help to
increase anti-theft effectiveness.

When Password Protect is Enabled

When "Power ON Protect" is Enabled (ON)

When the power is turned on for the first time after the projector's power
cable is connected to the electrical outlet, or when Direct Power On is
carried out, the following password entry screen will be displayed.
Use the numeric keypad on the remote control to set the password.
sp.48
If the correct password is entered, projection will then start.
If you leave the power cable connected to the electrical outlet and turn the
projector's power on when it is in standby mode, projection will start
without the password entry screen appearing. The password entry screen
will only be displayed when the power is turned on for the first time after
the power cable has been disconnected and then reconnected. If Direct
Power On is set to "ON" and you are using a circuit breaker or similar to
centrally control the power, the password entry screen will be displayed the
first time the projector is turned on after the power supply is restored.
TIP
• If an incorrect password is entered three times in succession, the
message "The projector's operation will be locked." will be displayed
for approximately five minutes, and then the projector will switch to
standby mode. If this happens, disconnect the power plug from the
electrical outlet and then reinsert it and turn the projector's power
back on. The screen requesting you to enter the password will be
displayed, so enter the password correctly.
If you forget the password, make a note of the "Request Code:
xxxxx" number that is displayed on the screen, and contact the
nearest address provided at "International Warranty Conditions"
section of the Safety Instructions/World-Wide Warranty Terms
booklet.
• If the above operation should happen to be repeated 30 times without
a correct password being entered, the following message will be
displayed and the projector will accept no more password entry. "The
projector's operation will be locked." Contact the nearest address
provided in the "International Warranty Conditions" section of the
Safety Instructions/World-Wide Warranty Terms booklet.
User's Guide
47