Epson EMP-835 User Manual page 37

Turning the Projector On Turning the Projector On
• If using the EMP-835, EasyMP will be detected as a source while
CardPlayer is running with a memory card or a USB device, or while
Network Screen is activated. While EasyMP standby screen or
setting screen is displayed, the EasyMP screen will not be displayed
by pressing the [Search] or [Source Search] button. Press the
[EasyMP] button on the remote control or the [Computer/
Component] button on the projector's control panel to switch the
source to EasyMP.
• If the input source is not detected correctly, try once more with
different images.
• If the "No Signal." message does not disappear, check the
connections again.
• If an image signal that is not supported is detected, a message will be
displayed and source searching will stop.
• If a laptop computer or a computer with an LCD screen has been
connected to the projector by a computer cable and the images are
not be projected straight away, after starting projection, check that
the computer has been set up to output signals externally.
The following table shows examples of how to toggle output settings.
For details, refer to the section of the documentation provided with
your computer under a heading such as "External output",
"Connecting an external monitor" or similar.
NEC Panasonic Toshiba IBM
[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]
• If the same still picture is projected for a long period of time, the
projected image may become burned in on the computer screen. You
should avoid leaving the same image displayed for long periods.
Sony Fujitsu Macintosh
Set mirror setting or
display detection.
You can press the buttons shown in the following table to select
the desired input source directly.
You can also use the preview function to select the input source
while viewing the input signal images.
Remote control
User's Guide
36
sp.52
Projector