Epson EMP-835 User Manual page 118

Problem Solving
Error messages from EMP Monitor
Check
The password is incorrect.
Cannot connect to the projector of the IP
address entered.
An incorrect password was entered. Enter the correct password. If you forget the password, check
the "Password for WEB control " setting in the "Wired LAN" - "Basic" or the "Wireless LAN" -
"Basic" configuration menu.
• If using the EMP-835
Check that "Wired LAN Connect Mode" or "Access Point Mode (Wireless LAN)" setting is being
used in the EasyMP configuration settings for the projector to be connected. If "Easy Connect
Mode" is selected in the "Wireless LAN" - "Basic" configuration menu, change the setting to
"Access Point Mode".
Next, check the "IP Address" setting in the "Wired LAN" - "Basic" or the "Wireless LAN" -
"Basic" configuration menu, and specify that IP address when connecting in IP connection mode.
s"Registration Using IP Address (Manual
If connection is still not possible, check the network settings at the computer and the EasyMP
network settings at the projector.
For details on network settings: s"Connecting in Access Point Mode or Wired LAN Mode" in
the EasyMP Network Setup Guide
• If using the EMP-830
Select "Extended" - "Network" in the configuration menu for the projector to be connected, and
then check the IP address. Specify this IP address when connecting in IP connection mode.
s"Registration Using IP Address (Manual
If connection is still not possible, check the network settings at the computer and at the projector.
sp.90
Remedy
Registration)" in the EMP Monitor Operation Guide
Registration)" in the EMP Monitor Operation Guide
User's Guide
117