Turning The Projector Off - Epson EMP-835 User Manual

Turning the Projector Off

Follow the procedure below to turn the projector off.
PROCEDURE
Turn the power off for the signal sources that are
1
connected to the projector.
Check that the power for all connected components has been
turned off.
Press the [Power] button on either the remote control
2
or the projector's control panel.
The following confirmation message will appear.
Remote control
If you do not want to turn the power off, press a button other
than any of the following:
• At the remote control: [Power], [ ], [ ], [ ], [Num], [ID]
• At the control panel : [Power]
If you do not press any button, the message will disappear
automatically after seven seconds. (The power will not turn off
at this time.)
Caution
If the message "The projector is overheating. Clean or replace the air
filter and lower the room temperature." appears on the screen, press
the [Enter] button on either the remote control or the projector's
control panel to turn the power off and then clean the air filters.
sp.119
Press the [Power] button on either the remote control
3
or the projector's control panel once more.
The lamp will switch off. The Power indicator will change to lit
orange.
Changes to lit orange
TIP
• The projector has a direct power off feature. If the projector is
being used in a room such as a meeting room where the power is
controlled centrally, the power can be turned off by operating a
circuit breaker without pressing the [Power] button.
• The projector's power cable can be disconnected immediately after
using the projector and the projector can then be moved.
• If "Standby Mode" in the configuration menu is set to "Network
ON", fans will continue operating. This is normal and does not
indicate a problem.
User's Guide
44