Perimetr Inst; Using Perimetr Inst; Turn On The Perimeter With No Delays - Bosch Security System User Manual

PERIMETR INST ?

Turn On the Perimeter With No Delays

Description
Use this function to turn on only the perimeter of your building,
leaving the interior of the building disarmed. This function allows
no exit or entry delay time through the perimeter, including the
designated exit delay door.
This function is useful in residential systems when everyone is
home and ready to retire for the evening. You can have the
security of an armed perimeter, yet move freely throughout the
interior of the premises.
It is also useful in commercial systems when you are working
before or after business hours and wish to arm the perimeter.
Remember there are no entry or exit delays when you use this
function. You must disarm (turn off) the system to enter or exit
the premises.

Using Perimetr Inst:

1. Interior points are not armed with this command and
might remain faulted while arming with COMMAND 2.
2. Press the COMMAND bar. The display shows SYSTEM
COMMAND.
3. Press the 2 key.
Note: If you prefer, you might use the Command Menu in place
of steps 2 and 3 to initiate this function. Press the MENU
key to enter the Command Menu, then press NEXT
repeatedly until you reach the PERIMETR INST ?
prompt. Press ENT.
4. The display shows PERIMETR INSTANT. After arming
the perimeter without delays, you cannot enter or exit
the premises without disarming the system. Opening a
perimeter door before disarming generates an alarm. If
this happens, silence the alarm by turning your system off
and call your security company to notify them that it is
not an emergency situation.
2