Advertisement
Table of Contents
DRIVER and PASSENGER - TRUNK SIDE MOUNTS
TOOLS REQUIRED:
HARDWARE:
LINE DRAWING:
• Read all instructions before installing any Havis, Inc. products.
• Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
• Use hardware provided with install kit
INSTALL INSTRUCTIONS
C-TSM-CV-D and C-TSM-CV-P
1996-2008 CROWN VICTORIA
• Drill with 1/8" and 3/16" drill bits
• Open End Wrench - 3/8"
• Phillips Screwdriver
QTY:
DESCRIPTION:
3
10/32 X 1/2" Machine Screw
3
10/32 Keps Nut
3
#10 x 3/4" Sheet Metal Screw
Passenger Side shown
# C-TSM-CV-P
Always!
Havis, Inc.
75 Jacksonville Road, PO Box 2099
Warminster, PA 18974
T
800-524-9900
F
215-957-0729
www.havis.com
PART #:
GSM33118
GSM30028
GSM33195
C-TSM-CV-P_INST_6-09
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Havis 1996-2008 Crown Victoria Driver and Passenger - Trunk Side Mounts C-TSM-CV-D
Summary of Contents for Havis 1996-2008 Crown Victoria Driver and Passenger - Trunk Side Mounts C-TSM-CV-D
- Page 1 INSTALL INSTRUCTIONS C-TSM-CV-D and C-TSM-CV-P 1996-2008 CROWN VICTORIA DRIVER and PASSENGER - TRUNK SIDE MOUNTS TOOLS REQUIRED: • Drill with 1/8” and 3/16” drill bits • Open End Wrench - 3/8” • Phillips Screwdriver HARDWARE: QTY: LINE DRAWING: • Read all instructions before installing any Havis, Inc. products. •...
- Page 2 Installation: Position frame assembly as shown. Trunk liner does not have to be removed, but you may want to cut it as needed to improve access for routing wires. Bottom frame mount attaches to the trunk side floor. Drill three pilot holes with a 1/8” (.125”) drill bit.
Need help?
Do you have a question about the 1996-2008 Crown Victoria Driver and Passenger - Trunk Side Mounts C-TSM-CV-D and is the answer not in the manual?
Questions and answers