Installation:
Position frame assembly as shown.
Trunk liner does not have to be removed, but
you may want to cut it as needed to improve
access for routing wires.
Bottom frame mount attaches to the trunk
side floor. Drill three pilot holes with a 1/8"
(.125") drill bit.
* Always check under floor before drilling *
Attach bottom frame with three (3) - # 10 x
3/4" sheet metal screws.
Top frame mount attachs to the trunk
gasket mounting flange.
Drill three holes with a 3/16" (.187") drill bit.
Attach top frame with three (3) - 10/32" x
1/2" machine screws and keps nuts.
Driver side Trunk Side Mount complete.
Install electrical components as desired.
Havis, Inc.
75 Jacksonville Road, PO Box 2099
Warminster, PA 18974
T
800-524-9900
F
215-957-0729
www.havis.com
C-TSM-CV-P_INST_6-09
2