Schwinn 112 Parts List, Full Size Hardware Chart, Product Illustration, Assembly Instructions page 12

1. Attach the LOWER COMPUTER CABLE (#10) from the MAIN UNIT (#14) to
the UPPER COMPUTER CABLE (#9) from the bottom of the
COMPUTER/HANDLEBAR MAST (#6).
2. Slide the COMPUTER/HANDLEBAR MAST (#6) onto the MAIN UNIT (#14).
3. Fasten the COMPUTER HANDLEBAR MAST to the MAIN UNIT with the
8mm BOLTS (#8) and CURVED WASHERS (#7) and tighten.
4. Place HANDLEBAR ASSEMBLY (#2) in the groove on the
COMPUTER/HANDLEBAR MAST (#6) and place HANDLEBAR CLAMP
(#26) over the top of the middle of the HANDLEBAR (#2) aligning the steel tabs
inside the receiver holes. Fasten with the T-KNOB (#22), T-KNOB BUSHING
(#23), SPRING WASHER (#10), and WASHER (#11).
5. Attach HR CABLE extending from the HANLBARS (#2) into the Jack on the
COMPUTER/HANDLEBAR MAST ASSEMBLY (#6).
page:12/16