Selecting A Special Mode - Sharp MX-2301N Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting a special mode for fax is explained below.
The settings that must be selected vary for each special mode, however, the general procedure is the same. The
procedure for erasing shadows at the edges of the image when sending a fax is explained below as an example.
The side to be scanned must be face up!
Ready to send.
Fax Scan Send
Mode Switch
Auto
A4
Job Detail
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
Fax
Special Modes
Program Erase
(2)
Timer 2in1
Special Modes
Erase
Edge Edge+Centre
Erase Erase
70
Speaker
Resend
Address Book
Sub Address
Special Modes
(1)
File
Quick File
OK
1/3
Dual Page
Scan
Card Shot
OK
Cancel OK
(4)
Edge
15 (0~20)
mm
(3)
1
Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2
Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Erase] key.
The erase settings will be configured to
erase a width of 15 mm around the edges
of the original.
(3) Set the erasure width to 15 mm with
the keys.
The erase area is set to "Edge Erase" by
default.
To select "Centre Erase", "Edge+Centre
Erase", or "Side Erase", touch the
appropriate key.
(4) Touch the [OK] key.
3
Enter the fax number of the receiving
fax machine and press the [BLACK &
WHITE START] key.
Cancel scanning