Selecting A Special Mode - Sharp MX-2700N Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting settings for a special mode is explained below. The settings that must be selected
vary for each special mode, however, the general procedure is the same. The procedure for selecting settings for
"Adding margins (Margin Shift)" is explained below as an example.
The side to be scanned must be face up!
Ready to scan for copy.
Full Color
Color Mode
Job Detail
Settings
Auto
1.
Exposure
8 x11R
2.
3.
100%
4.
Copy Ratio
Special Modes
Margin Shift
Erase
(2)
Job
Pamphlet Copy
Build
Special Modes
Margin Shift
Right Left Down
34
2-Sided Copy
Original 8 x11 1 / 2
Output
8 x11 1 / 2
Special Modes
8 x11 1 / 2
(1)
1 / 2 File
8 x14 1 / 2
11x17
Quick File
OK
1/4
Dual Page
Copy
Tandem
Copy
OK
(4)
Cancel OK
Side 1 Side 2
(0~1) (0~1)
3/4 3/4
inch inch
(3)
or
1
Place the original.
When using the document glass, place the original
with the side to be scanned face down.
2
0
Select the desired special mode
(example: margin shift) settings in the
touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Margin Shift] key.
Settings to shift the left margin by 3/4" will be
selected.
(3) Select 3/4" for the front side and 3/4" for
the reverse side using the
(4) Touch the [OK] key.
The margin shift position is initially set to
"Right".
To change the position to "Left" or "Down",
touch the corresponding key.
3
Set the number of copies and then press
the [COLOR START] key or the [BLACK
& WHITE START] key.
Correct sets
keys.
Cancel scanning Cancel copying