Subscribe to Our Youtube Channel
Related Manuals for Clarke GSE RANGE
Summary of Contents for Clarke GSE RANGE
- Page 1 SUBMERSIBLE PUMP SUBMERSIBLE PUMP GSE RANGE OPERATION & MAINTENANCE INSTRUCTIONS 1102...
- Page 2 Cable-Lock For Float (GSE 2A) GM1017 Connection 2” x 50 GM1095 Nipple From 2” to 2” IMPORTANT: The use of parts other than CLARKE replacement parts may result in safety hazards, decreased tool performance and may invalidate your warranty. -14-...
- Page 3 Service@clarkeinternational.com Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machines data plate...
- Page 4 GSE 2/2A Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machines data plate...
- Page 5 Safety Precautions Parts Diagram (GSE 150 &150A) WARNING: As with all machinery, there are certain hazards involved with their operation and use. Exercising respect and caution will considerably lessen the risk of personal injury. However, if normal safety precautions are overlooked or ignored, personal injury to the operator even damage to the pump or property, may result.
- Page 6 Electrical Connections Parts List (GSE 1 & GSE 1A) 230 Volt models: INDEX PART NUMBER DESCRIPTION Connect the mains lead to a standard 230 Volt (50Hz) electrical supply through an GM7099 Inox Screw approved BS1363, 13amp plug or a suitably fused isolator switch. GM7144 Inox Nut GM7206...
- Page 7 This pump should require little or no maintenance other than regular cleaning. If the pump starts to show signs of wear or damage, contact you nearest CLARKE dealer for advice. Do Not use the pump if there is any damage to the mains supply or float switch cable.
- Page 8 Check the pump installation regularly to ensure the base inlet is clear of leaves or other foreign objects, mud silt etc. if the pump starts to show signs of wear or damage, contact your nearest Clarke dealer for advice. DO NOT ATTEMPT TO CARRY OUT REPAIRS TO THE PUMP YOURSELF UNLESS YOU ARE FULLY COMPETENT.
Need help?
Do you have a question about the GSE RANGE and is the answer not in the manual?
Questions and answers