Install And Wire Telephone Power Supplies - Avaya CMC1 Installation Manual

Installing and Cabling the Cabinets
Hard-Wire Bridging
!
CAUTION:
Bridging or paralleling these endpoints can cause electrical damage to the
consoles or cause the circuit pack to remove power from the consoles.
Analog type hard-wire bridging is not allowed for 4-wire (only) DCP endpoints.
This is because hard-wire bridging provides no way of combining the digital output
of 2 bridged DCP sets. Also, a bridged endpoint causes the added load to
degrade the DCP signal.
Dual Wiring of 2-Wire and 4-Wire Endpoints
Do not simultaneously wire a 2-wire and 4-wire endpoint to the same equipment
location in an MDF, even though they connect to different colored wire pairs. The
system uses separate circuit packs to interface 2- and 4-wire endpoints, and none
are capable of interfacing both.
Install 26B1 Selector Console — Optional
1. Connect the supplied 3-foot (0.9 m) D8AC cable to the modular jack on the
bottom of the 26B1 Selector Console.
2. Route the cable to the attendant console and connect to the DXS/BLF jack.
3. Attach labels according to the Attendant Console form.
4. Administer the console using Administrator's Guide for Avaya
Communication Manager.
Administer IP Stations and Trunks
For complete information on administering IP stations and trunks, see
Administrator's Guide for Avaya Communication Manager.
Install and Wire Telephone Power
Supplies
This section provides information and wiring examples of installation procedures
for various telephone and console power supplies. These are examples only and
actual wiring procedures may vary at each site.
NOTE:
Refer to the Installation for Adjuncts and Peripherals for Avaya
Communication Manager, 555-233-116, to install the necessary peripheral
equipment.
1-70
Issue 7 November 2003 555-233-118