Lenovo ThinkServer User Manual page 71

Menu item
SATA Configuration
(set SATA configuration
parameters)
PCI Configuration (set PCI
configuration parameters)
Submenu item
SATA Mode
SATA Port0
SATA Port1
SATA Port2
SATA Port3
SATA Port4
SATA Port5
Onboard Graphics
Controller
Primary Graphics
Onboard LAN1 I/O ROM
Selections
• Power on
• IDE Mode
• AHCI Mode
• RAID Mode
• Disabled
• Enabled
• Onboard
• Add-On
• Disabled
• Enabled
Chapter 5
Comments
If the power is interrupted
when the server is on, after
the power resumes:
• If you have selected Stay
off, the server will stay in
the off state.
• If you have selected Last
State, the server will
resume to the last state.
• If you have selected
Power on, the server will
restart automatically.
Select SATA controller
operation mode. If you
want to configure RAID,
choose RAID Mode for the
SATA controller.
View the information about
the SATA device connected
to the SATA connector 0 on
the system board.
View the information about
the SATA device connected
to the SATA connector 1 on
the system board.
View the information about
the SATA device connected
to the SATA connector 2 on
the system board.
View the information about
the SATA device connected
to the SATA connector 3 on
the system board.
View the information about
the SATA device connected
to the SATA connector 4 on
the system board.
View the information about
the SATA device connected
to the SATA connector 5 on
the system board.
Enable or disable
the onboard graphics
controller.
Choose a mode for primary
graphics. The Add-On
option requires a graphics
card installed.
Enable or disable the
onboard LAN1 I/O ROM.
.
Configuring the server
59