Table of Contents
Advertisement
Assembly Instructions
4. Attach the plastic covers
A.
Using 6 x screws (C1) attach the plastic covers to
the base of the uprights.
Part No.
C31
6 mm screw x 6
MAKE SURE THE SCREWS ARE FULLY TIGHTENED WITH THE SCREWDRIVER.
Final check
Please make the following final checks before you use it for the first time.
•
Make sure all screws / bolts are tightened.
•
Make sure you have positioned it on a flat, level surface.
Power up
1.
Plug one end of power cable into the treadmill as shown.
2.
Plug the other end into a suitable AC outlet (220 - 20 volt, 50Hz)
.
Switch the treadmill on using the on / off switch.
.
Attach the safety key to the console.
NOTE: BEFORE YOU RUN ON THE TREADMILL FOR THE FIRST TIME, USE THE QUICK START INSTRUCTIONS ON
PAGE 11 AND ALLOW THE TREADMILL TO RUN INDEPENDENTLY FOR 10 MINUTES. CHECK THE RUNNING MAT
IS TIGHTENED CORRECTLY AND RUNS SMOOTHLY. IF YOU THINK THE MAT NEEDS ADJUSTING PLEASE SEE
PAGE 15 FOR MORE DETAILS.
8 • CHALLENGER Definition Treadmill | OWNER'S MANUAL
ChallengerDefinitionTreadmill_In8 8
safety switch
On/OFF
power cord
11/23/08 3:14:14 PM
Hide quick links:
Advertisement
Table of Contents
