Installing Hardware - Emerson MVME3100 Series Installation And Use Manual

Hardware Preparation and Installation
Table 1-6 EEPROM Address Settings (continued)
Device Address
$AC
$AE
The RTM EEPROM address switches must be set for address $AA in order for this device to be
accessible by MotLoad.
1.5

Installing Hardware

Damage of the Product and Additional Devices and Modules
Incorrect installation or removal of additional devices or modules may damage the
product or the additional devices or modules.
Before installing or removing additional devices or modules, read the respective
documentation.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal of the product can
damage circuits or shorten their life.
Before touching the product make sure that your are working in an ESD-safe
environment or wear an ESD wrist strap or ESD shoes. Hold the product by its edges and
do not touch any components or circuits.
Product Malfunction
Switches marked as "Reserved" might carry production-related functions and can
cause the product to malfunction if their setting is changed.
Do not change settings of switches marked as "reserved".
30
A(2:0) SW1
110 ON
111 OFF
MVME3100 Single Board Computer Installation and Use (6806800M28C)
SW2 SW3
OFF OFF
OFF OFF