Disabling Front Panel Or Remote - Zektor HDS4.1 User Manual

Step 1: Enter the Enable / Disable Control State
Z E K T O R
1
1
Start by pressing and
holding the Power
button...
Step 2: Enable or Disable Front Panel and / or IR Control Functions
ZEKTO R
1
4 HDS4.1 Component Video Switch
2 3 4
2
...while continuing to hold the Power
button, press and hold the '4' button.
3
After about 4 seconds, the standby LED
will flash quickly, and the display will indi-
cate the current enable / disable statuses.
2 3 4
Enable / Disable
IR Control Functions
Enable / Disable
Front Panel Buttons
Exit Setup Mode

Disabling Front Panel or Remote

I f you are not planning on using a remote control with your HDS4.,
you might want to disable its remote control func tion.
Or if you have a household with young cur ious fingers that likes
playing with buttons, you also have the capabilit y of disabling the
front panel switches and only operating the HDS4. with a remote.
To enable/disable the front panel switches or remote capabilities...
Step 1: Enter the Enable / Disable control state
1. First press and hold the Power button
2. While continuing to hold the Power Button, press and hold
the '4' button.
3. Af ter holding both buttons for about '4' seconds, the stand-
by LED will star t flashing quick ly indicating you are now
able to enable / disable front panel buttons and IR control
func tions.
•
The front panel selec tion LEDs now indicate the state of the
front panel and IR control settings:
I f '' is lit, then the Front Panel buttons are ENABLED.
I f '4' is lit, then the IR remote func tions are ENABLED.
Step 2: Enable or Disable Front Panel and / or IR control
•
Use the '' button to ENABLE / DISABLE the front panel
buttons.
•
Use the '4' button to ENABLE / DISABLE the IR remote con-
trol func tions.
•
When finished, press the 'Power ' button to save new set-
tings and retur n to nor mal operations.
Note 1: The HDS4.1 will not allow you to disable both the front
panel and IR controls at the same time.
Note 2: D isabling the front panel buttons does not disable the
abilit y to enter the S etup Modes. Even with the front
panel disabled you c an per form the above steps, allow-
ing you to once again enable the front panel buttons.
HDS4.1 Component Video Switch