Something not working
If the appliance is not working correctly, please carry out the following checks, before contacting your local Service
Force Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation,
a charge will be made even if the appliance is under guarantee.
SYMPTOM
! ! ! ! !
The cooker does not operate.
! ! ! ! !
The ceramic hob is not giving satisfactory results.
! ! ! ! !
The oven does not come on.
! ! ! ! !
The oven light does not come on.
! ! ! ! !
It takes too long to finish the dishes, or they are
cooked too fast.
! ! ! ! !
Steam and condensation settle on the food and the
oven cavity.
! ! ! ! !
The oven fan is noisy.
! ! ! ! !
The display shows "12.00".
! ! ! ! !
An error code, for example F..., appears on the
control panel.
If after all these checks, the cooker still does not work, contact your local Service Force Centre.
SOLUTION
" " " " "
Check that the unit is plugged in and the electrical
supply is switched on.
" " " " "
Check the mains fuse has not blown.
" " " " "
Check the correct control knob has been turned.
" " " " "
Check the cooking pan is the correct size for the
cooking zone.
" " " " "
Check the cooking pan has a flat base.
" " " " "
Check the setting is correct for the type of cooking.
" " " " "
Switch on the oven using push button
" " " " "
Check that the oven door is completely closed.
" " " " "
Check that the time of day has ben set (see
chapter "To set the correct time of day").
" " " " "
Check that the socket switch or the switch from the
mains supply to the cooker are ON.
" " " " "
Check the light bulb, and replace it if necessary
(see "Oven Lamp replacement").
" " " " "
The temperature may need adjusting.
" " " " "
Refer to the contents of this booklet, especially to
the chapter "Using the Oven".
" " " " "
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
" " " " "
Check that shelves and bakeware are not vibrating
in contact with the oven back panel.
" " " " "
Set the time of day (see chapter "To set the correct
time of day").
" " " " "
Take note of the error code and contact an authorised
Service Centre.
.
25