Cleaning Function - Zanussi ZCC 6680 Instruction Booklet

How to use the pyrolytic

cleaning function

Before activating the pyrolytic cleaning function,
remove any excessive spillage and make sure
that the oven is empty. Do not leave anything
inside it (e.g. pans, grids, baking tray, dripping
pan, etc.) as this could heavily damage them.
Ensure that the oven door is closed before
activating the pyrolytic cleaning function.
When the pyrolytic cleaning function is on, it is
advisable not to use the hob. This could cause
overheating and damage to both appliances.
During the pyrolytic cleaning cycle the oven door
becomes hot. Children should be kept away until
it has cooled.
Before activating the pyrolytic cleaning function, remove
the shelf supports.
To remove the oven shelves and the shelf supports
proceed as follows:
1. keep the shelf support in position with the other hand
(diagram 1);
2. then, disengage the rear hook and take off the shelf
support (diagram 2).
Please, ensure the retaining nuts are secure when
refitting the shelf support.
The following pyrolytic levels are available:
Pyrolytic 1 (P I) time : 2 h = 30 min heat-up +1 h at
480°C + 30 min cooling down.
Pyrolytic 2 (P 2) time : 2 h 30 min. = 30 min heat-up
+1 h 30 min at 480°C + 30 min cooling down.
The pyrolytic duration time cannot be changed.
To activate the pyrolytic cleaning function proceed as
follows:
1. Press button to switch on the oven. Press the
button as often as necessary, until the pyrolytic
function symbol
display (Fig. 19).
Simultaneously the symbol indicating the shelf
supports and the "Pyro" writing will flash in
the display and an acoustic signal will be emitted
(Fig. 20).
This means that, before activating the pyrolytic
cleaning function, you have to remove the shelf
supports and all the oven accessories (see
instructions above mentioned).
20
(level 1 - P I) appears in the
1
2
Fig. 19
Fig. 20