CONTENTS Instructions for the user Instructions for the installer Technical Features After Sales Service Warnings Instructions for the installer Description of the appliance Installation Use of the appliance Oven lamp replacement Advice for use Change of gas Maintenance and clening What to do if the appliance does not work Guarantee conditions...
TECHNICAL FEATURES Free standing Classe 1 Cover Enamelled Pan support Enamelled Front right Rapid 2,6kW Back right Auxiliary 1,0kW Front left Semirapid 2,0kW Back left Semirapid 2,0kW Oven Oven electric Over power 1700W Grill for the models ZCC5064 and ZCC5067 electric Grill power 1800W...
WARNINGS • In case you use electric appliances near the It is very important that this instruction book should be kept safety for future consultation. If it cooker (for instance an electric mixer) the should be sold or given to another person, please cables should not come into touch with the hot ensure that the booklet goes together with it, so parts of the cooker or fastened by the oven...
Page 5
• For reasons of good culinary results, hygiene and safety this appliance must always be kept clean, the fat sprinklers could give off unpleasant smells. • Clean your cooker after each use for guaranteeing a right functioning. • Never use steam or high pressure appliances for cleaning the oven (exactingness related to electric safety).
DESCRIPTION OF THE APPLIANCE Control panel Model : ZCC 5061 ZANUSSI OVEN ZCC 5061 OVEN OVEN FRONT IGNITION BACK FRONT BACK KNOB LEFT SWITCH PILOT LEFT RIGHT RIGHT BURNER BURNER BURNER BURNER CONTROL CONTROL CONTROL CONTROL KNOB KNOB KNOB KNOB...
Page 7
2000W 1000W 2600W 2000W 3. Back right burner (auxiliary) Front left burner (semi-rapid) 4. Front right burner (rapid) Back left burner (semi-rapid)
USE OF THE APPLIANCE 1. Electric traditional oven Before the first use ensure that the room is well ventilated: V.M.C. (Mechanic ventilation) or opened window. How to proceed ? 1. Lift the lid 2. Remove the oven accessories 3. Detach the adhesive labels, the foil protection if there is 4.
Page 9
Control knob (fig.1) It makes possible to choose the most appropriate temperature and to select the elements radiating heat one by one. Explanations of symbols: Off positions Oven light Temperature selection 50-250 Bottom heat Top heat fig. 1 Grill for the models ZCC5064 and ZCC5067 To select the temperature turn the knob clockwise until the pointer indicating the...
Page 10
For turning off the heating elements. Turn the knob clockwise to position off“ ”. Cooking in the oven Traditional cooking Traditional cooking is made by natural convection the heated air circulates on the principle of ascending and descending draughts. It is necessary to pre-heat the oven How to proceed ? For small cakes, pastry, beaten mixture cakes in moulds.
Page 11
Grilling Only models ZCC5064 ZCC5067 Heat comes from the top of the oven. It is suitable for grilling meat (beef bacon, pork bacon …) that remains tender, for toast or to brown already cooked. When using the grill it has to be supervised, the oven door opened the protective screen in its place.
Page 12
Oven light It’s lighted once the oven / grill knob is turned on and lights during the oven functioning. Oven thermostat pilot light Switches off when the oven reaches selected temperature and re-lights every time the thermostat intervenes to stabilize the temperature.
Page 13
How to chose the burner Good use Above every knob there is a symbol for the corresponding burner. For better cooking results, always chose pans which properly fit to the diameter of the burner used (fig. 10). We advise to lower the flame as soon as the liquid starts boiling.
ADVICE FOR USE Oven cooking Influence of the pots on oven cooking • results Turn off your oven 5 minutes before the foreseen cooking time you will save power, the accumulated heat will allow You have to know that: • to end cooking;...
MAINTENANCE AND CLEANING Before cleaning, check that the Self-cleaning oven knobs are on “off” position, that the Only models ZCC5061 appliance has cooled completely and ZCC5064 that it is disconnected. Principle: The walls of your cooker, except the soil are Never use abrasive powder or wire protected by special porous enamel.
Page 16
Oven Enamelled parts: Same cleaning as other enamelled parts. Oven door cleaning For a complete cleaning of the oven door it is advisable to dismantle as follows: -open the door completely (fig.12) -revolv the two blocking parts on the hinges arms completely up.
WHAT TO DO IF THE APPLIANCE DOES NOT WORK If the appliance does not work properly, check the following points before asking for service; there could be simple problems that you could remedy by yourself; if not, contact your after sales service.
GUARANTEE CONDITIONS abnominal power variation, etc., or non- Guarantee stipulated in the contract 1 year starting from setting into function the observing of the installation and use manufacturer will replace the damaged conditions stipulated in the Instruction book, wrong handling, negligence parts except the cases mentioned in chapter wrong, installation non-conforming to the...
INSTRUCTIONS FOR THE INSTALLER Electric connection ADVICE FOR SAFETY Check that: • Before installation ensure that the local • the power of the installation is enough; distribution conditions (gas nature and • supplying lines good pressure) and the pre-setting of the conditions;...
INSTALLATION Placement Remove the plastic packaging and install the cooker in a dry, ventilated room (fig. 15) not near curtains, paper, alcohol, petrol, etc…) The appliance has to be set on a heatproof soil. This appliance belongs to class “1” in matters of protection against overheating of surrounding surfaces.
Page 21
Gas connection Your cooker is delivered adjusted for the kind of gas stated on the rating plate. It might be necessary to pass to another kind of gas, different to the one it is preset to. Under these circumstances follow the instructions bellow.
Page 22
• Place the cooker checking that the loop made by the flexible pipe develops in Fitting the sanitary empty of the furniture. Rigid pipe • Rigid pipe with screw nut Holder butane 2. For cylinder butane propane gas: Flexible rubber •...
Electrical connection Before connecting check that: • Important fuse and household electric installation can bear the charge of the appliance (see rating plate); In any connection way the appliance • The socket or the omnipolar switch used has to be grounded, in accordance with for connection is easily reachable when the national rules in force.
Page 24
CHANGE OF GAS Your cooker is foreseen to work with G20 to 20 mbar. Your cooker is foreseen to work with natural gas, propane or butane. It is not foreseen for butane or propane air. For changing the gas type it is necessary to: •...
Page 25
Replacement of the nozzles Every appliance has spare nozzles for every gas. The whole of every nozzle is marked in microns on the nozzle. For changing the nozzles: 1. Remove the pan support; 2. Remove the burners; 3. Using a socket spanner 7 unscrew the nozzles (fig.