Table of Contents
Advertisement
The Hotplates
Spills onto the actual plate should be removed using
warm water and a soft brush, nylon or plastic scourer.
To keep the plates looking as new, hotplate
conditioner can be purchased from most hardware
stores, e.g. "4 Hob" by Homecare Products (follow
the manufacturer's instruction for use). Alternatively,
wipe the plates with a drop of olive oil on a kitchen
towel to avoid rust. It is important to note that the
plate will smoke a little and produce a slightly
unpleasant odour when next used.
Drying
Important: After cleaning, dry the hotplates
thoroughly by switching on to a low-medium setting
for a few minutes.
Restoring
To maintain the appearance of your sealed hotplates
apply a little salt-free vegetable oil or restorative
agent periodically.
To apply vegetable oil: first heat the hotplate on a
medium setting for 30 seconds then turn off. Pour a
very small amount of salt-free oil onto a dry cloth or
kitchen paper. Apply a thin coat of oil to the hotplate
surface and wipe off any excess. Heat the hotplate on
a medium setting for 1 minute.
Stainless steel parts: the stainless steel spill rings
may become straw coloured with use. Use a
proprietary stainless steel cleaner to remove this
straw discolouration.
This also applies to the area around the hotplates on
stainless steel hobs.
Something not working
If the appliance is not working correctly, please carry
out the following checks, before contacting your local
Service Force Centre.
IMPORTANT: If you call out an engineer to a fault
listed below, or to repair a fault caused by
incorrect use or installation, a charge will be
made even if the appliance is under guarantee
14
Oven bulb replacement
Ensure that the appliance is switched off
and disconnected from the electricity supply
before replacing the bulb to avoid possibility of
an electric shock.
If the oven bulb needs replacing, it must comply with
the following specifications:
Wattage
Voltage
Temperatures
Thread Type
To replace the faulty bulb.
1. Turn the glass cover anticlockwise and remove.
2. Remove the faulty bulb and replace with a new
one.
3. Refit the glass cover.
4. Reconnect the appliance to the electricity supply.
15W
230/240V(50Hz)
300ºC
E14
Advertisement
Table of Contents
