Table of Contents
Advertisement
al speed and set to 1 to slow the rotational speed, the system default setting is 8.
PRESET: Ranges from 1~32 for PELCO-D protocol camera and 1~255 for PEL-
CO-P protocol camera, the system default setting is 1 for both protocols. When 0
is display, the preset is not use.
Press the Menu/ESC button on the front panel, RC or right mouse click on the
mouse at anytime to exit out from the PTZ setup window.
Button function Front Panel / Remote Control
[SEL/EDIT]: To select or increase value.
[Up][Down]:Move the cursor up and down accordingly.
[REC]:Reduce Value or Auto-scan.
[Ch1][Ch2]: Move the dome upwards and downwards.
[Ch3][Ch4]: Move the dome leftwards and rightwards, increase/decrease value.
[STOP]:Stop the dome.
[REW][FWD]:Zoom.
[Pause][Play]: Focus.
Mouse function
Left Mouse button: Click the icon "►" or "◄" to adjust value.
Right Mouse button: Previous.
Preset setup
To setup a preset position for the dome; choose a Preset 1~255 (depend on pro-
tocol), click on PTZ mode, right mouse click to bring up the Icon function (below),
adjust to desire angle view, click on exit, and then press on Save Preset. To
check or recall the preset, select the Preset and then click on Call Preset.
Note: The address, protocol and baud rate of DVR should be setup according to
the dome's requirement, please reference the dome's user's manual for setup
detail.
Auto scan can be performed when presets are configured within cruise locus.
45
Advertisement
Table of Contents
