Table of Contents
Advertisement
GETTING STARTED
Install a SATA hard disk drive into HDD bracket located at the back of LCDDVR4
panel by removing the four screws (Philips) from the HDD bracket. Connect the
data and power cable to the SATA hard disk drive, seat the HDD bracket back
into the slot and secure it with the four screws. Hook up to 4 cameras with BNC
interface into the video inputs of the DVR. Connect the PS/2 mouse, external
sensors (if any), alarm, GND cable, audio in/out, and etc. into the DVR back
terminals. Plug the power adapter into the back of the DVR and the other end
plugs into an electrical outlet. Power on the DVR by switching the main power
ON, located at the lower left corner of the back panel and then both the DVR and
LCD monitor will automatically boot up the user interface screen. Press the REC
button to start the recording process and press the PLAY button to start playback
recorded file. More detail overviews of this summary below.
Note: If the power adapter is accidently unplugged or there is a power failure during
recording and when the power comes back; the DVR will detect the failure,
enter "Power Recovery" mode, and then reinitiate the recording process.
14
Advertisement
Table of Contents
