Table of Contents
Advertisement
Basic Operation
Binary Switches
Binary switch modules can be turned ON or
OFF. They cannot be set to in-between levels as
multi-level (dimmer) switch modules can.
To control a binary switch module, use the
following steps:
1. From the Home Screen press the HOME
SERVICES button.
2. From the Manage Z-Wave Devices Screen, press
the SWITCHES button.
3. A list of all installed switches will be displayed.
If there are more than three switches, use the ↑
or ↓ arrows to scroll the list. On the right side of
the switch button, binary switches will display
the current status of the switch (OFF or ON).
✓ NOTE: If the light or load is controlled at the
module while the Control Panel is showing
this display, press the REFRESH button to
update the display.
4. Press the display where the device is listed to
display the control buttons for the switch.
5. A check box indicates if the switch is OFF or ON.
Press the desired action for the switch (OFF or
ON). The lamp or load connected to the selected
binary switch module will follow your command.
6. Press the BACK button three times or the
button on the Control Panel to exit Home
Services.
6
Press
SWITCHES
button
Manage Z-Wave Devices Screen
Press device
button
Installed Switches Shown
Check box for
On or Off
Binary Switch Settings Display
Advertisement
Table of Contents
