Network Setup; Adding Devices - 2gig Technologies Go Control 2GIG-CNTRL2 Operation & User’s Manual

Network Setup

Adding Devices

Before a device will work in the home control
network, it must be added (also called included)
into the network.
To add one or more switch or thermostat
devices into the network, use the following
steps:
1. Install the Z-Wave Device as directed by the
device's instructions. If it is a lamp or appliance
module, connect the lamp or load to the module
and be sure the power switch on the lamp or
load is ON.
2. From the Toolbox Screen, press the ADD
DEVICES button. The Control Panel will display
"Discovering devices" and wait for a signal from
a device.
3. Press and quickly release the program button
on the device. (This button may also be called
"bind", "learn", or may not be labeled.)
4. When the device is discovered, the display will
show its kind, type, manufacturer, and network
node information assigned to the device.
5. Repeat Steps 3 and 4 for any additional devices
that need to be added to the network at this
time.
6. Press BACK when fi nished.
If additional Z-Wave compatible devices are
purchased, and your home control network
expands, these steps can be used at any time
to add additional devices.
Devices can only be included once in the
network. The system will not allow a device to
be added multiple times to the same network.
4
Add Z-Wave Devices Screen
PRESS Z-WAVE
DEVICE BUTTON
Pressing the Device's Programming Button
New device
shows on
screen
Added Devices Shown