Scenes & Rules; Controlling Multiple Devices; Creating Scenes; Z-Wave Switches - 2gig Technologies Go Control 2GIG-CNTRL2 Operation & User’s Manual

Scenes & Rules

Controlling Multiple Devices

Beyond simple controlling of a single device,
multiple device control commands can be
assigned using a " Scene". A Scene can be run
on its own, or " Rules" can be assigned to trigger
a Scene after a Control Panel "event" such as
arming your system or when an alarm occurs.

Creating Scenes

Scenes are created by assigning one or more
device actions to the Scene. The multi-function
Scene can then be easily executed by pressing
the Scene's RUN button.
To create a Scene, use the following steps:
1. From the Home Screen press the HOME
SERVICES button.
2. From the Manage Z-Wave Devices Screen, press
the SCENES button.
3. From the Z-Wave Scenes Screen press the ADD
SCENE button.
4. Use the alphanumeric keypad displayed to enter
a name for the new Scene. Press OK when
fi nished.
5. Press the ADD button.
6. Press Z-WAVE
THERMOSTAT to add one of these device types
as an action to the Scene.

Z-Wave Switches

7A. Use the ← or → arrows to choose a switch
device (if there is more than one device), then
select an ON, OFF, or a dimming level for the
switch. Press OK.

Z-Wave Thermostats

7B. Use the ← or → arrows to choose a thermostat
device (if there is more than one device), then
select a mode, setpoint, and fan setting for the
thermostat. Press OK.
✓ NOTE: The device will not activate while
setting Steps 7A & 7B. The scene must be
"run" or triggered by an event with a "rule".
8. The assigned action(s) for the Scene will be
displayed. Repeat Steps 5 through 7 to add
additional actions to the Scene. Press BACK
when fi nished.
✓ NOTE: Only one action per device can be
assigned per Scene.
9. Test the Scene by pressing RUN. A Scene
execution confi rmation screen will be displayed,
press OK.
10
SWITCH or Z-WAVE
Press ADD SCENE
button
Z-Wave Scenes Screen
Press a device type
for the action
Create Action Screen
Choose a device, then
set the action
New Switch Action Screen
Choose setpoints and
modes
New Thermostat Action Screen
New Scene with Actions Screen
Press RUN button to
run the scene
Scenes Screen with RUN Button