Table of Contents
Advertisement
E_8gt.book Page 27 Tuesday, March 28, 2006 5:37 PM
ESU05090
Adjusting the control rods
The weight transfer can be adjusted by turning the con-
trol rod adjuster or adjusting nut.
1. Loosen the locknut 1.
2. Turn the control rod adjusting nut 2 in direction a to
increase weight transfer or direction b to decrease
weight transfer.
3. Tighten the locknut while holding the adjusting nut in
place.
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
CAUTION :
@
G
When using the two wrenches included in the
owner's tool kit, make sure that they are situated
at a right angle to the control rod as shown, and
that they are tightly fitted to the locknut and the
control rod adjusting nut.
G
The left and right adjusting nuts must be set to
the same position. Uneven settings can cause
poor handling and loss of stability.
@
WARNING
@
Never adjust the control rods beyond the maximum
range indicated on the rods with red paint 3.
@
c Adjustable range
d Standard position
8-27
Advertisement
Table of Contents
