Table of Contents
Advertisement
E_8gt.book Page 10 Tuesday, March 28, 2006 5:37 PM
A
B
ESU00035
Parking brake lever
When parking the snowmobile or starting the engine,
apply the parking brake by moving the brake lever 1 to
the left.
To release the parking brake, move the parking brake
lever 1 to the right.
È To apply the parking brake
É To release the parking brake
WARNING
@
G
Always set the parking brake before attempting to
start the engine.
G
Never run the snowmobile with the parking brake
applied. This may overheat the brake disc and
reduce braking ability.
@
ESU00039
Headlight beam switch
Push the headlight beam switch to change the headlight
beam to high or low.
1 Headlight beam switch
2 Push
3 High beam
4 Low beam
ESU04301
Auxiliary DC jack
The auxiliary DC jack is located in the front panel and
can be used for accessories.
NOTE:
@
The auxiliary DC jack cannot be used if the engine is not
running.
@
1. Start the engine.
2. Open the auxiliary DC jack cap 1, and then insert
the accessory power plug into the jack 2.
NOTE:
@
After using the auxiliary DC jack, be sure to remove the
accessory power plug from the jack and close the auxil-
iary DC jack cap.
@
5-10
Advertisement
Table of Contents
