Table of Contents
Advertisement
E_8gt.book Page 6 Tuesday, March 28, 2006 5:37 PM
Left and right side covers
To remove a side cover
Turn the fasteners counterclockwise, and then remove
the side cover.
1 Fastener
2 Right side cover
3 Left side cover
To install a side cover
Place the side cover in its original position, and then turn
the fasteners clockwise.
NOTE:
@
Be sure to fit the projection on the rear of the side cover
into the hole in the lower side cover.
@
Top cover
To remove the top cover
1. Remove the screws, and then remove the cable
guide.
2. Remove the bolts, disconnect the main switch cou-
pler and auxiliary DC jack coupler, and then remove
the top cover.
1 Screws
2 Cable guide
3 Bolts
4 Top cover
To install the top cover
1. Connect the main switch coupler and auxiliary DC
jack coupler, place the top cover in its original posi-
tion, and then install the bolts.
2. Pass all of the cables, etc., through the cable guide,
place the cable guide in its original position, and then
install the screws.
8-6
Advertisement
Table of Contents
