Table of Contents
Advertisement
E_8gt.book Page 15 Tuesday, March 28, 2006 5:37 PM
Replenishing the coolant
WARNING
@
G
Do not remove the coolant reservoir cap when
the engine is hot. Scalding hot fluid and steam
may be blown out under pressure, which could
cause serious injury.
When the engine has cooled, place a thick rag or
towel over the coolant reservoir cap, and slowly
rotate the cap counterclockwise to the detent.
This procedure allows any residual pressure to
escape. When the hissing sound has stopped,
press down on the cap while turning counter-
clockwise and remove it.
G
The cooling system must be bled of air if the
coolant reservoir becomes empty, if air can be
seen in the cooling system, or if there is a cooling
system leak. Consult a Yamaha dealer.
@
1. Remove the top cover. (See pages 8-5–8-7 for
removal procedures.)
2. Remove the coolant reservoir cap, fill the reservoir
with the recommended coolant, and then install the
cap.
3. Remove the coolant recovery tank cap, add the rec-
ommended coolant until it reaches the "COLD
LEVEL" mark, and then install the cap.
Recommended coolant:
High quality ethylene glycol antifreeze containing cor-
rosion inhibitors.
Antifreeze and water mixing ratio:
60:40
Total amount:
6.0 L (5.28 Imp qt, 6.34 US qt)
1 "COLD LEVEL" mark
2 Coolant reservoir cap
3 Coolant recovery tank cap
8-15
Advertisement
Table of Contents
