Table of Contents
Advertisement
Switching off
The gas burner does not
light
3. Push the control dial in fully and hold for
1 3 seconds. The gas that flows is ignited by
the ignition spark.
This activates the safety function, which automatically
cuts the gas supply to the burner concerned if the
flame goes out.
The ignition function must not be operated for longer
than 15 seconds. If the burner has not lit after
15 seconds, you should stop operating the ignition
function. Wait at least one minute before trying to light
the burner again.
4. Set the desired flame height. The flame is not
stable between the OFF and • settings. For this
reason, you should select a setting between the •
maximum and – minimum flame settings.
5. Check that the flame is lit. Otherwise repeat the
process from step 2.
6. Turn the control dial clockwise to the OFF
position.
d
If you operate the control dial for a burner that is still
warm shortly after you have switched it off, gas will
flow out. If the control dial is not moved to the :
ignition position within 60 seconds, the safety function
will be activated and the gas supply will be cut off.
If there is a power cut, or if the ignitors are damp, you
can light the gas burners with a piezo gas lighter or a
match.
25
Advertisement
Table of Contents
