Iv. Starting The Navigation Software - Medion Navigation Unit Operating Instructions Manual

IV. Starting the Navigation Software

Note
The map material will always have to be stored in the device during the
use of the navigation system if your memory card contains such (addi-
tional) material.
It will be necessary to carry out a reset to restart the navigation system if
the memory card has been removed while the system was being used
(see page 32). According to the navigation system the reset is carried out
automatically.
1. Switch on your navigation system.
2. The Navigation software will start automatically or after tapping on the navigation
control button on the main screen, according to the version.
3. Tap on Navigation on the screen for entering the destination and enter the ad-
dress of your navigation destination. Confirm your entry by clicking the
to start the navigation. You will receive the route information on the screen, aug-
mented by language statements, after a short time, if the satellite reception is ade-
quate.
Further information regarding the navigation software can be found in the comprehen-
sive manual on your navigation CDs/DVDs. This is a pdf-file you can read and print
with the any Acrobat Reader.
Note
The GPS-receiver will require some minutes for initialization when de-
ployed for the first time. Even when GPS signal reception is indicated the
navigation could be imprecise. In all future instances it will take about
30-60 seconds until a correct GPS-signal is available, sufficient "sight" of
the satellite is a prerequisite.
Navigation
symbol
39