Iv. Starting The Navigation Software - Medion Navigation Unit Operating Instructions Manual

IV. Starting the Navigation Software

Note
Your memory card will always have to be inserted into the device during
the use of the navigation system, if the card contains (additional) mapping
material.
It will be necessary to carry out a reset to restart the navigation system if
the memory card has been removed while the system was being used (see
page 22). According to the navigation system the reset is carried out
automatically.
1. Switch on your navigation system.
2. The Navigation software will start automatically or after tapping on the naviga-
tion control button on the main screen, according to the version.
3. Tap on Navigation on the screen for entering the destination and enter the
address of your navigation destination. Confirm your entry by clicking the
symbol to start the navigation. You will receive the route information on the
screen, augmented by language statements, after a short time, if the satellite re-
ception is adequate.
Further information regarding the navigation software can be found in the comprehen-
sive manual on your navigation DVD. This is a pdf-file you can read and print with
the any Acrobat Reader.
Note
The GPS-receiver will require some minutes for initialization when de-
ployed for the first time. Even when GPS signal reception is indicated the
navigation could be imprecise. In all future instances it will take about 30-
60 seconds until a correct GPS-signal is available, sufficient "sight" of the
satellite is a prerequisite.
UK/ N. IRELAND HELPLINE 0871 37 61 020
REP. IRELAND HELPLINE 1-800-992508
- 29 -