Iv. Starting The Navigation Software - Medion Navigation Unit Operating Instructions Manual

Hide thumbs Also See for Navigation Unit:

Table of Contents

IV. Starting the Navigation Software

Note

Your memory card will always have to be inserted into the device

during the use of the navigation system, if the card contains (addi-

tional) mapping material.

It will be necessary to carry out a reset to restart the navigation sys-

tem if the memory card has been removed while the system was be-

ing used (see page 22).

Switch on your navigation system.

The Navigation software will start automatically or after tapping on the

navigation control button on the main screen, according to the version.

Tap on Navigation on the screen for entering the destination and enter the

address of your navigation destination. Confirm your entry by clicking the

symbol to start the navigation. You will receive the route information on the

screen, augmented by language statements, after a short time, if the satellite

reception is adequate.

Further information regarding the navigation software can be found in the com-

prehensive manual on your navigation CDs/DVDs. This is a pdf-file you can

read and print with the any Acrobat Reader.

Note

The GPS-receiver will require some minutes for initialization when

deployed for the first time. Even when GPS signal reception is indi-

cated the navigation could be imprecise. In all future instances it will

take about 30-60 seconds until a correct GPS-signal is available, suffi-

cient "sight" of the satellite is a prerequisite.

Navigation

Table of Contents

Mp3 player