Starting The Navigation Software - Medion Navigation Unit Manual

V. S
TARTING THE NAVIGATION SOFTWARE
i
Note: The memory card must always be inserted in
the device while the navigation system is being used.
It will be necessary to carry out a Soft Reset to re-
start the navigation system if the memory card has
been removed, only for a short time, while the sys-
tem was being used (see page 25). This Reset will
take place automatically, according to the navigation
system.
1. Switch on your navigation system.
2. The Navigation software will start automatically or after
clicking on the Navigation control button on the main
screen, according to the version.
3. Press on the button for entering the destination
ter the address of your navigation destination. Then start
the navigation by clicking on Navigate. You will receive the
route information on the screen, augmented by language
statements, after a short time, if the satellite reception is
adequate.
Further information regarding the navigation software can be
found in the comprehensive manual on your navigation
CD(s). This is a pdf-file you can read and print with the any Acro-
bat Reader.
Note: The GPS-receiver will require some minutes
i
for initialization when deployed for the first time.
Even when GPS signal reception is indicated the
navigation could be imprecise. In all future instances
it will take about 30-60 seconds until a correct GPS-
signal is available, sufficient "sight" of the satellite is a
prerequisite.
N
AVIGATION
and en-
33