Setting The Clock - Sharp XL-MP8H Operation Manual

Setting the clock

In this example, the clock is set for the 24-hour (0:00) display.
1
Press the SHIFT button and then the CLOCK button. Within
8 seconds, press the SHIFT button and then the MEMORY
button.
2
Within 1 minute, press the PRESET (
lect 24-hour or 12-hour display, then press the SHIFT but-
ton and then the MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
3
Within 1 minute, press the PRESET (
just the hour, then press the SHIFT button and then the
MEMORY button.
Press the PRESET (
by 1 hour. Hold it down to advance continuously.
4
Within 1 minute, press the PRESET (
just the minutes, then press the SHIFT button and then the
MEMORY button.
Press the PRESET (
by 1 minute. Hold it down to advance continuously.
To confirm the time display:
Press the SHIFT button and then the CLOCK button.
The time display will appear for about 8 seconds.
Note:
or ) button to se-
The "0:00" or time will flash when the AC power supply is restored
after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the "0:00" is not
flashing in step 1, step 2 (for selecting the 24-hour or 12-hour dis-
play) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 23 for details.]
2 Perform "Setting the clock" from the beginning.
05/4/18
or ) button to ad-
or ) button once to advance the time
or ) button to ad-
or ) button once to advance the time
XL-MP8H(H)E1.fm TINSZA056SJZZ
XL-MP8H
ENGLISH
8
E-10