Leg Extension Foot Tube Installation; Leg Assembly Extension Tube - Bowflex Ultimate Assembly Manual

Assembling Your BOWFLEX Ultimate Leg Assembly
Step 1: LEG EXTENSION FOOT TUBE INSTALLATION
Locate the following parts:
• Leg extension main frame (Item #62)
• Leg extension foot tube (Item #63)
• Two (2) 3/8"X3" bolt (Item #51)
• Two (2) 3/8" nylon lock nuts (Item #57)
• Four (4) 3/8" washers (Item #54)
Insert the leg extension foot tube (Item #63) into the
leg extension main frame (Item #62) saddle bracket,
aligning the holes in the bracket with the holes in the foot
tube, as shown in Figure P.
Insert two 3/8"X3" bolts (Item #51) with 3/8" washers
(Item #54) through the holes in both tubes as shown in
Figure P.
Install 3/8" washers (Item #54) and then 3/8" nylon
lock nuts (Item #57) onto the bolts and securely tighten.
Components for this step
are in the Leg Extension Box
Step 2: LEG ASSEMBLY EXTENSION TUBE
Locate the following parts
• Leg extension main frame (Item #62)
• Leg extension pivot tube (Item #64)
• 3/8"X3" bolt (Item #51)
• 3/8" nylon lock nut (Item #57)
• Two (2) 3/8" washers (Item #54)
Untwist the twist-tie that is holding the
bushings in place in the leg extension pivot tube
(Item #64).
Place the leg extension tube (Item #64) as
shown in Figure Q. The tube is symmetrical so
orientation does not matter.
Insert the 3/8"X3" bolt (Item #51) with a 3/8"
washer (Item #54) on it through the leg
extension main frame (Item #62) and through
the leg extension tube (Item #64) as shown in
Figure Q.
Install a 3/8" washer (Item #54) onto the bolt
and securely tighten the 3/8" nylon lock nut
(Item #57).
Components for this step
are in the Leg Extension Box
62
Figure P
57
54
54
51
57
54
64
51
Figure Q
63
Unit appears like
this following this
assembly step
54
Unit appears like
this following this
assembly step
17