Seat Rail Installation; Seat Installation - Bowflex Ultimate Assembly Manual

Assembling Your BOWFLEX Ultimate
10
Step 7: SEAT RAIL INSTALLATION
The following parts are required for this step:
• Seat Rail (Item #10)
• One (1) 3/8"X5" bolt (Item #53)
• Two (2) 3/8" washers (Item #54)
• One (1) 3/8" nylon lock nut (Item #57)
• Large Knob (Item #37)
If you have not already done so, remove
the twist-tie that holds the rail spacer blocks
and tube in place on the side of the seat rail.
Slide the seat rail, right side up, into the
main frame and rest it on the cross bar as
shown in Figure F.
Slide the 3/8"X5" bolt (Item #53) with a
washer through main frame and seat rail as
shown in Figure F. Place 3/8" washer (Item
#54) and 3/8" nylon lock nut
(Item #57) on bolt and tighten.
Place the large knob (Item #37) into the
hole in the top of the frame and tighten.
Step 8: SEAT INSTALLATION
Locate the following parts for this step:
• Seat Assembly
Pull out and lock the pin on the left side of the seat
assembly and slide the seat onto the rail as shown in
Figure G.
Components for this
step are in Box 3
54
53
Figure F
14
Figure G
Unit appears
like this
following this
assembly step
37
54
57
Unit appears like
this following this
assembly step